Included: Naze board, 3-wide right angle header pins x6, 3-wide straight pins x6, 2-wide straight header pins x10, 2-wide right angle pins x1.
Note that returns on these are not accepted after soldering. Please plug the board into your computer BEFORE you solder it to check it works.
These change colour with every batch, so may not be red as pictured.
5.3 grams (no headers, 7.3 grams with)
2000 degrees/second 3-axis MEMS gyro + accelerometer (MPU6050)
Flexible motor outputs, support various airframe types -
Quad/Hexa/Tri/Bi/Y4/Y6/Octo/Camera Gimbal. (Default is Quad-X)
Up to 8 ch RC input - supports standard receivers (PWM), PPM Sum receiver (FrSky, etc), or Spektrum Satellite receiver.
Built in FrSky telemetry inverter (shared w/main port)
Battery voltage monitoring
Modern 32-bit processor running at 3.3V/72MHz (STM32F103CB).
16Mbit onboard SPI flash
Onboard MicroUSB for setup and configuration
LEDs so bright, they will blind you
MultiWii-based configuration software for easy setup
rev5 hardware Naze32
Made in JAPAN
Designed for use with small indoor or small to mid-sized outdoor multirotor craft, or as a standalone camera stabilizer, the Naze32 flight control is simple to setup, with configuration based on the familiar “MultiWii” software.
Colour of board may vary.